RetroTurbo.com is  an authorized re-seller of EcuMaster DET3 products.

Digital ECU Tuner 3 is the most popular and best type of “piggy back” device on the market. Due to its features and a very attractive pricing it has gained a large group of satisfied customers.

Technical details:
- Comes with 400kPa inbuild map sensor.
- Four 16×16 side tables (fuel map,two PWM tables, ignition table),
- 8 Correction tables 16×1,
- 2 independent switchable map sets ,
- Possibility modification of one analogue signal,
- 4 analogue inputs,
- Inbuilt Data Flash – possibility of logging without connected PC,
- Battery voltage monitoring,
- Support of frequency output air flow meter (possibility of signal modification) 17Hz-4kHz,
- Support VR and Hall effect crank sensors together with ignition modules pulse. Device supportbothsingle ended and differential signals,
- Supports a lot of crank trigger patterns :60-2, 36-2, 36-1, Multitooth, Ignition Modules and more,
- Support of waste gate valve,
- Output for 4 saturated injectors (“full group”),
- ON/OFF parametricoutput,
- Automatic conversion of MAP to MAF with the use of the learning algorithm,
- Launch control,
- Road dyno,
- Possibility individual calibration of each analogue sensors – device displayed values with correct units,
- Free firmware update – new crank trigger patterns and new functionality,
- Fuel Implant mode –possibility of drive injectors in standalone mode (batch fire),
- USB communication no additional interface needed,
- 24 months warranty.
What is in the box:

- Digital Ecu Tuner 3 device,
- USB AA lead,
- Connector,
- Set of terminals,
- CD with software necessary drivers and user manual,
- Set of resistors and diode which may be useful during installation.

By purchasing this product you agree to our T&C found here. Get in touch for your requirements through contact form. We deliver worldwide!